145.210 Repeater Installation

Saturday, April 20th @ 11 am the following club members arrived at our new location up on Oxbow road in Canastota for the installation of the Repeater and Antenna: W2ZXN, WB2RLL, KC2FEV, KA2JFU, KR2HWK, and KR2ECP that is Andy, Bruce, JJ, Dick, Marc, and Josiah respectively.  No rain was falling, but the clouds were set and the sun was hidden as the group started to unload and start the process of putting everything together. 2 geese decided to fly by and see what was going on at the initial start of the unloading. The view was beautiful with some of the Fenner Wind Turbines in the background.

It took about 10 minutes to unload and get everything into the garage and around back before the process of putting everything together could begin.  By 11:30 the antenna was on the ground and assembled into what was going to be stationed against the chimney. Three members of the group walked the mast up against the chimney and in place beside the current owner’s FM antenna.  It was around noon when the minor adjustments were all done. Resecuring the antenna to the top of the mast as it wasn’t tightened enough before going up and stand needed to be a little to better secure the mast to the chimney.

It was near to One o’clock when the repeater cables were ready to be attached to the Duplexer and antenna cable to the Repeater.  At this point, testing began and at first, all seemed to be working fine, until it was noticed that the high and low pass cables were swapped.  This was remedied and testing continued on the drive home after 2 pm. So far there are some good signal reports while there are some others with not as good a report.  Testing will continue to see what better signal footprint can be attained.

The help from all hands that were available that day was greatly appreciated.  It was a fun time and flies on the roof didn’t affect things too much, although it was a nuisance to JJ who became the default safety person and dedicated roof climber.  The equipment went up without too much of a hitch, but there are always little issues. During the testing phase, some adjustments will be made and hopefully, these will improve the use of the repeater.

Here is a little gallery of what happened that day:

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.